Hank Breedlove Machine Shop         P.O. Box  12756       Gastonia, NC  28052

     EMAIL:  breedlove1@bellsouth.net               PHONE:   704 853 8746 

HANK

BREEDLOVE  MACHINE  SHOP

A customer said he had some old antennas' hanging in the garage and wanted these three antenna packs of different sizes to try and tune them by making them longer.  He was already using my quick disconnect.     They are 2" and 3" and 4" inches in length longer than the normal size one pictured without the nut.  For all three as pictured with the nuts:  $ 70.00

Any single extension:  $ 25.00

Now this strange little item was made for use onboard a cruise ship. The rail on the poop-deck (or whatever they called it) was at a forty five degree angle.  He wanted to clamp to the rail and be able to set the antenna back to vertical.  The clamp has a range of 3-3/4 inches, down to nothing.  The swing arm double locks to the circle in any position and is all aluminum construction. The clamp screws for one side are all that are needed down to 2 inches wide. If clamping to something smaller then screws are used on both sides. The screws are stainless steel.   Push plates are included for protecting the rail from marks. 

They are grounding screws on both sides of the base and where the antenna mounts.

Also incorporated but not shown, a hole in the circle so that the quick disconnect mount that is used on top will also install on the circle so the clamp can be used when you have to install to the side of a rail or table top.   No swing adjustment, but in most cases you would already be vertical.

Swing  Arm  Clamp

Price:  $ 175.00

COMPLETE

SET

2 INCH

3 INCH

4 INCH